huaju

Introduction to power-type PTC thermistor for inverter use to simulate power surge:

1. Application scope:

High-voltage and large-capacity energy storage capacitors are widely used in industrial products. Due to the characteristic that the voltage across the capacitor cannot change suddenly, at the moment the system is turned on, the current flowing into the capacitor from the grid energy often reaches a peak level of hundreds of amperes. Such a high The startup current seriously threatens the rectifier devices and overcurrent fuses in the circuit, and also brings great harmonic pollution to the public commercial power grid. Therefore, almost all circuits are equipped with a "start-up surge suppression circuit" to suppress the startup surge current to a reasonable level.

The traditional "surge suppression component" is a common fixed resistance "cement resistor". Especially in products with power above kilowatts, high-power "cement resistors" are commonly used as surge suppression components. From the original intention of designing the power-on surge suppression circuit, the fixed resistor can meet the basic function of the design - to suppress the power-on charging current.

However, the fixed resistor itself brings new safety hazards - due to the possibility that the relay connected in parallel with the "surge suppression component" cannot be effectively closed, such as mechanical fatigue, drive failure, load failure, etc., the continuous load current flow Passing this high-resistance fixed resistor (commonly used resistance is 10~100 ohms) will inevitably produce extremely high temperatures, causing the "cement resistor" to smoke, explode and other unsafe phenomena. In extreme cases, the PCB will be melted by the high temperature. Destroy or even ignite. This is a shortcoming of linear resistors in surge suppression applications. To solve this problem, Huaju Electronics has launched a positive temperature coefficient ceramic thermistor PTC with surge suppression function. Its unique positive temperature coefficient characteristic (that is, the resistance increases as the temperature increases) can effectively suppress the continuous increase in the temperature of the device itself. The temperature change process is as follows:

PTC has low temperature and low resistance => is heated by current => temperature increases => (when exceeding the PTC thermistor operating temperature) resistance increases => current decreases => thermal power decreases => PTC resistance continues to increase ( Until tens of KΩ) => heat generation and heat dissipation are balanced => PTC temperature is maintained near the operating point (about 130~150°C).

From the above analysis, it can be seen that the "resistance-temperature" positive correlation characteristic of Huaju Electronics' surge suppression PTC enables it to have a "self-protection" function - in the case of a fault where the relay cannot be closed, the thermal power generated by the load current It can only be heated to near the Curie temperature point, effectively avoiding the phenomenon of temperature runaway similar to "cement resistor", which means that it can safely protect itself and at the same time protect the downstream circuit located behind it, and after the relay fault is eliminated , it can also automatically restore its original functions.

Therefore, Huaju's surge suppression PTC thermistor provides help to improve the safety and reliability of switching power supplies. It is an ideal startup surge current suppression component. This product is gradually being widely used in air conditioners, industrial inverters, Provide safe and reliable power-on surge protection for power supply and other industries.

Model naming: